Though they won't come out mainly because they can't see any ground to peck at under all the white stuff. Foxy there is the grown-up cub of Broken Tail, a vixen who was suckling five cubs in broad daylight in the next door's garden (we're in a suburb, not in the country) two summers ago. Looks like one of them didn't want to leave home.
The weather has also interfered with my hunting - that is for a nice low mileage Honda Firestorm for 2K or under. As soon as that is in the bag I can order the Keihin flatside carbs from CA Cycleworks wth the money left over from selling the CB1300. In fact pretty soon I may just order them anyway - there are lots of reasonable 2K bikes around.
I have a vice for the workbench now, I have also been using my new hex drivers to take the headlight and clocks off of the Monster, and a mate of mine is donating a drill stand.
I've also bought a very nice Cyclecat billet top yoke to replace the ugly pig iron that was revealed when I removed the bars and risers. This new yoke is a piece of billet alloy artwork and should be much lighter too - will post pics when it arrives. Buying it has comitted me to sticking with the Monster non-adjustable Showa forks. I took advice on this from UK Monster Owner's Club. I decided I would have to prioritise and not convert front-end to superbike spec. (916 et al) forks which are 53mm mount rather than 50mm. The new yoke is standard M900 fit of 50mm (these measurements refer to the top yoke apertures for fork legs). UK MOC member, Zimbo's advice was that the stock forks where better than early SS 50mm adjustable forks. The key is to have them set up by professionals like MCT or Maxton. They won't look so techie with no adjustment, but the pilot's view will be nice and clean...
Ideally I would like to get a nice aftermarket shock and get back and front suspension fettled at the same time. That's a way off though. Next steps are all about the engine and the frame. I've ordered a puller for the left hand crankcase, which means I will be able to fit a lightweight flywheel, and maybe replace the starter motor which was getting stuck everynow and then.
Plenty to do, just need the snow to clear and the weather to warm up a tiny bit.....
